M14 and M1A Drill and Tap Scope Base


Drill and Tap Picatinny Scope Mount for M1A and M14 Rifles

 This is our Drill & Tap mount for all M1A and M14 Rifles.

This mount does not interfere with the iron sights when a scope is not mounted and does not use the side mount screw hole.  This mount slides into the stripper clip guide dovetail and uses two screws in the front receiver bridge, a 3rd screw can be used in the rear dovetail but is usually not needed as the dovetail will hold the mount securely.  This mount does require a gunsmith to drill and tap into the receiver.  Once installed the mount does not interfere with the iron sights so you can us quick release rings to alternate between optic and irons. The mount is made from 4140 Steel and is heat treated and blued.   The Mount is angled underneath so it does not obstruct case extraction.  You can click on the pictures below for larger versions.  The unit in the pictures is not blued the mounts when shipped will be matte black.  This is a patent pending design.

We sell just the mount for $125 or  we can sell you the mount installed on your rifle for $199.

Click here to go to our ordering page.

Click on any of the pictures for a larger version.

Expedtion Tactical M14 M1A scope Mount Expedtion Tactical M14 M1A scope Mount Expedtion Tactical M14 M1A scope Mount Expedtion Tactical M14 M1A scope Mount